Stainless steel sheet 4 mm blank
- Dimensions: right selectable up to 3000 x 1500 mm (10 mm = 1 cm)
- Thickness: 4.0 mm
- Alloy: 1.4301
-
Surface: Rolled, not foil-coated. Scratches will occur during cutting!
Thanks to its optimal weather resistance, this smooth sheet is also used outdoors as roof cladding, wall coverings, in facade construction, as drip protection, or as splash guards. Many customers also use this sheet as edge protection or impact protection to protect door leaves from kicks. It can also be used as a heat-conducting sheet, radiation shield, or reflector for lighting installations.
Alloy 1.4301, also known as V2A, is the most widely used stainless chromium-nickel steel. Due to its high chemical resistance to water and diluted acids, this steel is in high demand in the food industry and beverage production. Not for use in swimming pools. Contact with seawater should also be avoided, as chloride ions attack the material.
On request: Drilling according to sketch
We can also drill holes into your configured workpiece*.
Please select the number of holes from the menu. Shortly after your purchase is completed, we will automatically send an email requesting a sketch. Subject: "Drill holes for your order: AU ....., Order number: .....".
Be sure to read the PDF document attached to the email!
Then simply send us your sketch as a reply to this email. We need to be able to clearly identify the position of the hole center(s) and the hole diameter .
Without this sketch, your order cannot be started!
* Holes are circular. Slotted holes, countersinks, or rectangular holes are not possible!
The possible bore diameter depends on the material thickness:
Material thickness up to 1.25 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm Ø,
Material thickness from 1.5 to 2.5 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm, 8.5 mm, 9 mm, 9.5 mm, 10 mm, 12 mm Ø,
Material thickness from 3 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm, 8.5 mm, 9 mm, 9.5 mm, 10 mm, 12 mm, 13 mm, 14 mm, 15 mm, 16 mm, 17 mm, 18 mm, 19 mm, 20 mm Ø.
Note: Due to cutting with guillotine shears, both sides of the sheet will have scratches. This is unavoidable, normal, and therefore does not constitute grounds for complaint.
Thicker sheets and narrow strips will twist slightly during cutting, meaning they will twist/bend. The sheet will therefore not lie completely flat on a smooth surface. We cannot prevent or correct this!
We recommend having us deburr the sheets right away – you can select this inexpensive additional service from the dropdown menu on the right.
Non-deburred material has sharp edges. Please remember to wear appropriate protective clothing and gloves!
On request: Priority processing
If you need it particularly quickly, we offer priority processing for an additional charge. This means: If
we receive your prepaid order Monday through Thursday , it will be completed and shipped within 24 hours. The priority option (subject to an additional charge) must be selected for all items in the shopping cart; otherwise, the order will not receive priority processing! This service is not available for all items. If your order exceeds our material or personnel resources, we will contact you immediately to find a solution together. Please feel free to contact us
if you have any further questions !