U-profile made of oiled smooth sheet steel, galvanised smooth sheet steel or galvanised perforated sheet steel, double folded
Alloy: DC01 or DX51 D+Z
Material and edge angle selectable on the right!
Length and dimensions selectable on the right. Attention: Leg B must always be at least 5 mm longer than the shortest other leg, otherwise production is not possible!
All dimensions are internal dimensions in mm (10 mm = 1 cm)
Deburred edges - less risk of injury during assembly!
Choose from the following materials:
DC01: Raw smooth sheet steel, lightly oiled
DX51 D+Z: Galvanised sheet steel
Qg 10-15: Galvanised perforated sheet in square perforation, straight, hole width 10x10 mm, pitch 15 mm - 5 mm gaps remain around each hole
Rv 5-8: Galvanised perforated sheet with staggered round perforations, hole diameter 5 mm, pitch 8 mm - there are webs of at least 3 mm around each hole
These U-profiles from our own production are ideal as edge protection or for edging wooden worktops or steps. They can also be used as a cable duct, panelling, guide or slide-in strip, touch protection, decorative strip or cover strip.
On request: Drill holes according to sketch
We can also drill holes in your configured workpiece*.
Please select the number of drill holes in the menu. Shortly after completing the purchase, we will automatically send an e-mail requesting a sketch, subject: ‘Drill holes for your order: AU ....., order number: .....’.
Be sure to read the PDF document attached to the e-mail!
Then simply send us your sketch in response to this e-mail. We must be able to clearly identify the position of the borehole centre(s) and the borehole diameter.
Your order cannot be started without this sketch!
* Boreholes are circular. Oblong holes, countersinks or rectangular holes are not possible!
The possible hole diameter depends on the material thickness:
Material thickness up to 1.25 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm Ø,
Material thickness from 1.5 to 2.5 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm, 8.5 mm, 9 mm, 9.5 mm, 10 mm, 12 mm Ø,
Material thickness from 3 mm: 5 mm, 5.5 mm, 6 mm, 6.5 mm, 7 mm, 7.5 mm, 8 mm, 8.5 mm, 9 mm, 9.5 mm, 10 mm, 12 mm, 13 mm, 14 mm, 15 mm, 16 mm, 17 mm, 18 mm, 19 mm, 20 mm Ø.
New: Enter either internal or external dimensions!
For our self-folded products, all dimensions are specified as internal dimensions in millimetres as standard. We can easily and reliably fulfil your desired product dimensions with our specified tolerances.
However, you may need a specific external dimension for your application. As an exception, we therefore offer you the option of specifying dimensions as external dimensions. This service is subject to a surcharge!
The reason for this is that the production of flashings with specific external dimensions on our machines is considerably more complex. It requires a lot of experience and in many cases a series of tests with test pieces.
We therefore ask for your understanding for the surcharge. If the results of our tests are not satisfactory, we will unfortunately have to reject your order - but you will not incur any costs.
Please note: Due to the cutting and edging process, both sides of the sheet will show scratches.
Please note when entering your order: For production reasons, the web (leg B) must be at least 5 millimetres longer than the shortest other leg.